no use no use 1/1 no use no use
Question for RMII interface converter
by Unknown on Dec 14, 2003
Not available!
> I meet a problem of interface converter listed as below.

RMII uses the same bit order (transmission order, little) as MII. It
orders it's 2bit-words in the same order as MII order it's 4bit-words

Basically RMII is just the same as MII but smaller words.

The spec:s of your RMII-interface most likely describes this bit-order in

I could dig up some VHDL models of RMII from an academic project. That
project never flew on RMII, so the RMII-model is not verified against the
real world.

no use no use 1/1 no use no use
© copyright 1999-2023, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.