OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] [amber/] - Rev 66

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
66 Remove the stand-alone ethmac test. Use boot-loader-ethmac instead to verify ethmac functionality. csantifort 4176d 07h /amber/
65 Renamed boot-loader to boot-loader-serial csantifort 4176d 07h /amber/
64 Support latest Xilinx ISE 14.5 software. csantifort 4176d 07h /amber/
63 Add support for Xilinx ISim Verilog simulator.
Remove Virtex-6 files.
csantifort 4176d 11h /amber/
62 Added source for amber-pkt2mem csantifort 4329d 00h /amber/
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.
csantifort 4463d 06h /amber/
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4681d 02h /amber/
59 Added modelsim script for reloading a wlf file after a simulation has been rerun. csantifort 4750d 23h /amber/
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4751d 03h /amber/
57 Add some debug messages csantifort 4751d 03h /amber/
56 Remove the timeouts file from svn. Its an output file and gets now just gets created automatically
when sims are run for the first time.
csantifort 4751d 03h /amber/
55 Added sudo to rm mnt command csantifort 4751d 03h /amber/
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.
csantifort 4768d 03h /amber/
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4783d 01h /amber/
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4783d 01h /amber/
51 Revert vmlinux back to 48. csantifort 4824d 00h /amber/
50 Revert to previous version csantifort 4824d 00h /amber/
49 Added a note n how to change timeouts csantifort 4824d 01h /amber/
48 Fixed a bug in linux that caused the os to not return to the running application after an interrupt.
Hello-world now runs stand-alone again.
Added initrd-200k-dhry, a disk image that uses the dhry program for init.
csantifort 4828d 07h /amber/
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4848d 04h /amber/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.