OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] [amber/] [trunk/] [hw/] - Rev 64

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
64 Support latest Xilinx ISE 14.5 software. csantifort 4181d 08h /amber/trunk/hw/
63 Add support for Xilinx ISim Verilog simulator.
Remove Virtex-6 files.
csantifort 4181d 13h /amber/trunk/hw/
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.
csantifort 4468d 07h /amber/trunk/hw/
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4686d 03h /amber/trunk/hw/
59 Added modelsim script for reloading a wlf file after a simulation has been rerun. csantifort 4756d 01h /amber/trunk/hw/
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4756d 04h /amber/trunk/hw/
57 Add some debug messages csantifort 4756d 04h /amber/trunk/hw/
56 Remove the timeouts file from svn. Its an output file and gets now just gets created automatically
when sims are run for the first time.
csantifort 4756d 04h /amber/trunk/hw/
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.
csantifort 4773d 04h /amber/trunk/hw/
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4788d 02h /amber/trunk/hw/
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4788d 02h /amber/trunk/hw/
50 Revert to previous version csantifort 4829d 01h /amber/trunk/hw/
49 Added a note n how to change timeouts csantifort 4829d 02h /amber/trunk/hw/
48 Fixed a bug in linux that caused the os to not return to the running application after an interrupt.
Hello-world now runs stand-alone again.
Added initrd-200k-dhry, a disk image that uses the dhry program for init.
csantifort 4833d 08h /amber/trunk/hw/
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4853d 05h /amber/trunk/hw/
45 Store vmlinux.mem and vmlinux.dis in compressed form csantifort 4861d 03h /amber/trunk/hw/
43 Added support for the flat executable file format to vmlinux, so that the hello-world program is correctly relocated when it is loaded at the end of the vmlinux test.
Changed the Virtex-5 clock configuration to use a 1200MHz VCO frequency and 80MHz system clock frequency.
csantifort 4861d 04h /amber/trunk/hw/
42 Added write buffer - fixes bug if wishbone writes takes multiple cycles to complete csantifort 4879d 00h /amber/trunk/hw/
41 Added instructions on how to use Coregen to create the Spartan-6 DDR3 memory interface. csantifort 4880d 09h /amber/trunk/hw/
40 Added wishbone bus jitter testing option.
Cleaned up waveform log .do files, now seperate files for a23 and a25 cores.
Added vmlinux executable elf file for running on hardware.
csantifort 4885d 01h /amber/trunk/hw/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.