OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] [amber/] [trunk/] [hw/] [vlog/] - Rev 63

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
63 Add support for Xilinx ISim Verilog simulator.
Remove Virtex-6 files.
csantifort 4310d 01h /amber/trunk/hw/vlog/
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.
csantifort 4596d 19h /amber/trunk/hw/vlog/
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4814d 15h /amber/trunk/hw/vlog/
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4884d 16h /amber/trunk/hw/vlog/
57 Add some debug messages csantifort 4884d 16h /amber/trunk/hw/vlog/
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.
csantifort 4901d 16h /amber/trunk/hw/vlog/
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4916d 14h /amber/trunk/hw/vlog/
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4916d 14h /amber/trunk/hw/vlog/
49 Added a note n how to change timeouts csantifort 4957d 14h /amber/trunk/hw/vlog/
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4981d 18h /amber/trunk/hw/vlog/
43 Added support for the flat executable file format to vmlinux, so that the hello-world program is correctly relocated when it is loaded at the end of the vmlinux test.
Changed the Virtex-5 clock configuration to use a 1200MHz VCO frequency and 80MHz system clock frequency.
csantifort 4989d 16h /amber/trunk/hw/vlog/
42 Added write buffer - fixes bug if wishbone writes takes multiple cycles to complete csantifort 5007d 12h /amber/trunk/hw/vlog/
41 Added instructions on how to use Coregen to create the Spartan-6 DDR3 memory interface. csantifort 5008d 21h /amber/trunk/hw/vlog/
40 Added wishbone bus jitter testing option.
Cleaned up waveform log .do files, now seperate files for a23 and a25 cores.
Added vmlinux executable elf file for running on hardware.
csantifort 5013d 13h /amber/trunk/hw/vlog/
39 Added a second level of buffering to a25_wishbone_buf to fix a lockup
bug when write acks to not return immediately, and also to improve performance slightly
csantifort 5014d 14h /amber/trunk/hw/vlog/
38 support 128-bit wishbone now used for a25 core csantifort 5015d 14h /amber/trunk/hw/vlog/
37 128-bit wide boot memory module csantifort 5016d 12h /amber/trunk/hw/vlog/
36 Changed boot_mem for the a25 system to be 128 bits wide to match the 128-bit wide wishbone bus csantifort 5016d 13h /amber/trunk/hw/vlog/
35 Amber25 improvements:
Use 128-bit wishbone bus, instead of 32-bit to reduce cache miss fetch times
Use a fast barrel shifter for shifts between 0 and 4 to improve timing
Use a 2 cycle full barrel shifter for complex shifts
csantifort 5017d 21h /amber/trunk/hw/vlog/
32 Added clock cycle counting register to test_module to support dhrystone performance measurement csantifort 5020d 14h /amber/trunk/hw/vlog/
30 Bug fix - a write access was sometimes dropped when it was in a sequence of writes with variable wb_ack delays csantifort 5033d 20h /amber/trunk/hw/vlog/
27 Got working with cadence nc simulator csantifort 5068d 21h /amber/trunk/hw/vlog/
20 Added feature to A25 core to directly use a read value from the write back stage
to reduce the stall to 1 cycle when there is a register conflict with the
following instruction. This increases performance by about 3%.
csantifort 5102d 20h /amber/trunk/hw/vlog/
17 amber25 core bug fix. The return address for irq interrupts was off by 4 bytes
when the interrupt occurred during a stm instruction with the following instruction
having some register conflicts. Added test irq_stm to catch the bug.
Cleaned up some header descriptions
csantifort 5106d 18h /amber/trunk/hw/vlog/
16 Deleted the old version of the 3-state amber core. Its replaced with amber23.
Added the 5-state Amber core.
csantifort 5109d 08h /amber/trunk/hw/vlog/
15 Copied amber to amber23, Many system changes to support new amber25 core. csantifort 5109d 08h /amber/trunk/hw/vlog/
14 Re-wrote the behavioral clock generation code to more accurately
calculate the sys_clk frequency. The previous version was not
producing the correct frequency at higher frequenies due to
rounding errors.
csantifort 5110d 20h /amber/trunk/hw/vlog/
13 Bug fix - added an extra state to the rx state machine to properly align
reading the uart input to the middle of each bit.
csantifort 5110d 20h /amber/trunk/hw/vlog/
12 Added INITIALIZE_TO_ZERO parameter to keep instantiation
idendical to generic sram models. The parameter is not used
in the Xilinx models (they always init to zero) but it used
in the generic models.
csantifort 5110d 20h /amber/trunk/hw/vlog/
11 Added vmlinux test. csantifort 5125d 20h /amber/trunk/hw/vlog/

powered by: WebSVN 2.1.0

© copyright 1999-2025 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.