OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] [amber/] [trunk/] [hw/] [vlog/] - Rev 75

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
74 The patch implements barrel shifter using rotate as a main primitive.
The design was optimized for Altera Cyclone III FPGA and can be reused
with other FPGA vendors and products.
The patch integrates the FPGA-optimized barrel shifter into the
Amber 23 core when it is build for Altera FPGA.

The patch reduces footprint from 1178 to 339 LEs keeping Fmax at 57-60 MHz.

Contributed by: Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>
csantifort 4236d 20h /amber/trunk/hw/vlog/
73 The patch introduces a new configuration option `A23_RAM_REGISTER_BANK,
which controls instantiation of Amber 23 register bank.
If the option is set, a ram-based variant of the register bank is instantiated.
It can be useful in low-end FPGA designs, where flipflops and muxes are costly.

Altera Cyclone III resource utilization:
- flipflop-based register bank: 1583 combinationals + 856 registers
- ram-based register bank: 268 combinationals + 156 registers

Contributed by Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>
csantifort 4236d 20h /amber/trunk/hw/vlog/
72 5 bit "OH_USR" constant was used when 2 bit "USR" should be used.
Both of the constants are 0.
The fault was introduced by ram-based register bank commit.
Contributed by: Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>
csantifort 4236d 20h /amber/trunk/hw/vlog/
71 Original Amber 23 core uses asyncronous implementation of register bank.
It leads to some problems with ram-based implementation of the register bank,
because at least Altera FPGAs uses syncronous ram blocks, so the whole address
needs to be latched.

The patch exposes non-registered versions of register select signals to the
register bank, so the bank can build address and latch it in the syncronous
ram input register.

The patch is a pre-requisite for ram-based register bank implementation on Altera FPGA.

Contributed by Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>
csantifort 4236d 20h /amber/trunk/hw/vlog/
64 Support latest Xilinx ISE 14.5 software. csantifort 4236d 22h /amber/trunk/hw/vlog/
63 Add support for Xilinx ISim Verilog simulator.
Remove Virtex-6 files.
csantifort 4237d 02h /amber/trunk/hw/vlog/
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.
csantifort 4523d 21h /amber/trunk/hw/vlog/
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4741d 17h /amber/trunk/hw/vlog/
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4811d 18h /amber/trunk/hw/vlog/
57 Add some debug messages csantifort 4811d 18h /amber/trunk/hw/vlog/
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.
csantifort 4828d 17h /amber/trunk/hw/vlog/
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4843d 15h /amber/trunk/hw/vlog/
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4843d 15h /amber/trunk/hw/vlog/
49 Added a note n how to change timeouts csantifort 4884d 15h /amber/trunk/hw/vlog/
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4908d 19h /amber/trunk/hw/vlog/
43 Added support for the flat executable file format to vmlinux, so that the hello-world program is correctly relocated when it is loaded at the end of the vmlinux test.
Changed the Virtex-5 clock configuration to use a 1200MHz VCO frequency and 80MHz system clock frequency.
csantifort 4916d 18h /amber/trunk/hw/vlog/
42 Added write buffer - fixes bug if wishbone writes takes multiple cycles to complete csantifort 4934d 14h /amber/trunk/hw/vlog/
41 Added instructions on how to use Coregen to create the Spartan-6 DDR3 memory interface. csantifort 4935d 23h /amber/trunk/hw/vlog/
40 Added wishbone bus jitter testing option.
Cleaned up waveform log .do files, now seperate files for a23 and a25 cores.
Added vmlinux executable elf file for running on hardware.
csantifort 4940d 15h /amber/trunk/hw/vlog/
39 Added a second level of buffering to a25_wishbone_buf to fix a lockup
bug when write acks to not return immediately, and also to improve performance slightly
csantifort 4941d 16h /amber/trunk/hw/vlog/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.